Thursday, July 4, 2019

A Very Fairy Birthday Pop Out Card

Hello Everyone! Jenn here today sharing a whimsical Birthday card using the amazing Tutti Dies! Have you seen the newly released Fairy dies?? They are just adorable!!

I created this fun pop out card using the following dies:




Such a fun card to create!!
Cuts needed:
Black card stock base - 5 X 6.5
Pink card stock - cut 4 4 3/4 X 6 1/4 panels
Black and white patterned paper - cut 3 4 1/2 X 6 panels
Die Cuts:
Pink card stock - cut 5 dotted nesting squares - 2.25"
Pink card stock - cut 1 dotted nesting square - 2.625"
White card stock - cut 5 dotted nesting squares - 1.875"
White card stock - cut 1 dotted nesting square - 2.25"
Pink card stock - cut 1 dotted nesting rectangle - 2.375" x 1.125"
White card stock - cut 1 dotted nesting rectangle - 2.00" x 0.75"
Black card stock - cut 1 of each of the Mini Fairies set
Black card stock - cut 1 Fairy with wand - Add pink and white paper to back over hearts, wings, and mushroom dots.
Cut a 2" X 10" strip of black card stock. Score at 2 1/2, 5, 7 1/2
Assemble the inside of the card first as follows:
Adhere 1 pink panel followed by 1 black and white panel to each side.
Adhere the white squares 1.875" to the pink squares 2.25" - keep as uniform and straight as possible. You will have a total of five. Set one aside and adhere the mini fairies to the other 4. Place the completed fairy squares on the 2 1/2" scored sections of the black strip using score tape. Keep them aligned as you add each one. Next add some score tape to the back of the first section and last section of the strip and adhere to the card as seen below. Be sure that the center score line folds upward.
Now to assemble the front and back of the card.
Start by adhering a piece of ribbon to the edge of the back then follow with a pink panel.
For the front, adhere another piece of ribbon and then adhere the final pink panel on top of it. Allow this to dry before tying closed. Once glue is dry, adhere the white dotted 2.25 square to the Pink dotted 2.625" square. Adhere the white dotted rectangle to the pink dotted rectangle. Place these on the card as shown using foam adhesive squares to lift them up from the base. Add the Fairy with wand using foam adhesive strips and finish off with sentiments!
Such a fun whimsical card for someone's birthday! We all have whimsy lovers in our family and friends!

Here are some close ups of the amazing detail in these dies!




Thank You for visiting my post today!! I hope you are inspired to get out your tools and supplies and create!!

Be sure to visit the Tutti Designs Store  for all available die cuts in the most recent release along with the full inventory of Tutti Dies.

You'll find more inspiration on our other Tutti Designs sites:

Until Next Thursday, and always, stay crafty!!

Thanks! 
Jenn

No comments:

Post a Comment